Description:
The Cube is the heart of any pixhawk 2 based autopilot. Designed as a modular component the cube can fit onto a number of different carrier boards depending on the application. The Cube is the worlds most advanced autopilot for open autonomous unmanned vehicles. Redundant, temperature controlled, and vibration isolated. It runs either the PX4 or Ardupilot firmware stack giving you the ultimate flexibility with your drone.
The Cube will not function without a carrier board. This product listing is for the cube module on its own and does not include a carrier board.
Specifications
Processor
- 32-bit ARM Cortex M4 core with FPU
- 168 Mhz/256 KB RAM/2 MB Flash
- 32-bit failsafe co-processor
- Sensors
- Three redundant IMUs (accels, gyros and compass)
- InvenSense MPU9250, ICM20948 and/or ICM20648 as first and third IMU (accel and gyro)
- ST Micro L3GD20+LSM303D or InvenSense ICM2076xx as backup IMU (accel and gyro)
- Two redundant MS5611 barometers
Power
- Redundant power supply with automatic failover
- Servo rail high-power (7 V) and high-current ready
- All peripheral outputs over-current protected, all inputs ESD protected
Interfaces
- 14x PWM servo outputs (8 from IO, 6 from FMU)
- S.Bus servo output
- R/C inputs for CPPM, Spektrum / DSM and S.Bus
- Analogue / PWM RSSI input
- 5x general purpose serial ports, 2 with full flow control
- 2x I2C ports
- SPI port
- 2x CAN Bus interface
- 3x Analogue inputs (3.3V and 6.6V)
- High-powered piezo buzzer driver (on expansion board)
- High-power RGB LED (I2C driver compatible connected externally only)
- Safety switch / LED
(0 ) Reviews:
No reviews yet. Be the first to review!