iFlight Blitz F7 E55 Flight Stack (F7 + 55A 4in1 ESC)

Description:

FC Features

• Improved circuit design, better components, and lower electrical noise!
• DJI HD VTX Connector (Plug-and-Play / No soldering required)
• FC indicator LEDs for visual debugging
• With LC filter

FC Specifications

• MCU: STM32 F722Gyro: ICM42688Barometer: DPS310

  OSD Chip: AT7456E

  Flash: 8MB (Blackbox flash)

  UARTS: 6

  Motor outputs: 4x (SH1.0 connector)

  I2C serial: SDA / SLA pads

  Smartaudio / IRC Tramp VTX protocol supported

  LED controller: Yes

  Beeper pad: Yes

  Firmware target: IFRC-IFLIGHT_BLITZ_F722

  Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter

  Dimensions: 36.5*35 mm

  Weight: 7.8g

  BEC: 5V 2.5A / 9V 2A

  UART 1 for VTX HD / Analog
  UART 2 for a Receiver
  UART 3/4/5 for GPS or other sensors that require a serial port
  UART 6 for ESC Telemetry

ESC Specification

• Mounting Holes: 30.5*30.5mm/4mm
  Weight: 15.3g
  Supports 2-6S lipo input
  MCUG071
  Constant: 55 Amps
  Burst: 65 Amps
  Current sensor: Yes
  BEC: No
  Current rate: 200
  Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
  Target: IFLIGHT_BLITZ_G2

Included

• 1pc BLITZ F7 FLIGHT CONTROLLER
• 1pc BLITZ E55S 4-IN-1 2-6S ESC
• 1 set SILICON GROMMETS
• 1 set WIRE HARNESS FOR F7 FLIGHT CONTROLLER