Description:
The Crazybee F4 V3.1 Flight Controller comes pre-soldered with a Frsky SPI receiver and XT30 power wires. This flight controller is the default FC for TheFPFlea and the Happymodel Cine8 85mm Brushless CineWhoop, but great for other ultra-light micro drones that need space and weight savings.
Build your micro drone with this AIO flight controller and solve three things at once!
Just add a VTX like the Happymodel Diamond VTX and your stack is good to go!
Features
- No soldering work needed
- 5pin VTX wires... simply plug and play, and you are ready to go!
- XT30 Power Wires
- Built-In 12A 4-in1 ESC
- Built-In FrSky SPI Reciever
Specifications
Crazybee F4 V3.1 Flight Controller
- (Frsky SPI RX version) CRAZYBEEF4 V3.1 FC Firmware target: CrazybeeF4FR
- (External TBS CRSF NANO version) CRAZYBEEF4 V3.1 FC Firmware target: CrazybeeF4FR MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: MPU-6000(SPI connection)
- Board Size: 28.5x28.5mm
- Mounting Pattern: 25.5x25.5mm
- Power Supply: 2-4S Battery input (DC 7V-17V)
- Built-in Betaflight OSD(SPI Control)
- Built-in 5V 1A BEC
Onboard 12A 4in1 ESC
- MCU Upgraded to EFM8BB21
- Power Supply: 2-4S LiPo/LiPo HV (7v/17v)
- Con. Current: 12A
- Burst Current: 15A (5 seconds)
- Support BLHeliSuite programmable
- Factory firmware: F_H_40_REV16_8.HEX
- Default protocol: DSHOT600
Onboard Frsky SPI D8 Receiver Version
- CC2500 Hardware
- Compatible with FrskyD FrskyX Frsky_X_LBT SFHSS REDPINE protocol
- Channels: 8ch
- Failsafe support
- Diversity 2.4G receiver system
- No ground interference: above 300meter
Includes
- 1x Crazybee F4 V3.1 AIO Flight Controller
- 4x Screws
- 4x Damping Balls
- 8x Spacers
- 1x Pre-Soldered Connecting Wires
- 1x 2.4 Receiving Antenna
(0 ) Reviews:
No reviews yet. Be the first to review!