Happymodel Moblite7 Walksnail 1s 75mm Brushless HD Whoop

Name: Happymodel Moblite7 Walksnail 1s 75mm Brushless HD Whoop
SKU: BNF88941688
Availability: InStock

In Stock

★★★★★

(0 )

$82.00

$163.99

-50%

SKU:

BNF88941688

Category:

Motor vehicle parts

Free Shipping:

Free shipping on orders over $120.

Description:

Features

Lightweight 1S whoop with Walksnail Avatar Nano FPV TX unit onboard
Powerful and efficient
SuperBee F4 AIO Flight Controller
Walksnail Avatar Mini digital FPV system
EX1002 brushless motors
Low profile Canopy design

Specifications

Brand Name: Happymodel
Model: Moblite7 Walksnail
Frame wheelbase: 75mm
Weight: 33.5 gram without battery
Size: 98mm*98mm*50mm
Receiver option:
SPI ELRS 2.4GHz
SPI FRSKY 2.4GHz
Compatible with 1S Lipo battery or Lihv battery
Battery Plug: PH2.0

Flight controller SuperbeeF4 Lite ELRS/FRSKY	SPI ELRS version Firmware target: CrazybeeF4SX1280 SPI FRSKY version Firmware target: CrazybeeF4FR MCU:STM32F411CEU6 (100MHz, 512K FLASH) Sensor: ICM20689 or ICM42688P or BMI270(SPI connection) Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in SPI Frsky/ExpressLRS receiver Built-in 5V 1A BEC Built-in voltage detection
Onboard 4in1 ESC	MCU upgraded to EFM8BB21 Power supply: 1S LiPo/LiPo HV (2.8v~4.35v) Currents: 5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Factory firmware: O_H_5_REV16_8.HEX Default protocol: DSHOT150/DSHOT300/DSHOT600
Onboard SPI ExpressLRS 2.4GHz Receiver	Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz RF Frequency: 2.4GHz Telemetry output Power: <12dBm Receiver protocol: SPI ExpressLRS Could bind with ELRS V2.0 firmware TX module
Onboard Frsky SPI D8 /D16 2.4GHz Receiver	SPI BUS receiver Frsky D8/D16 compatible Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt) Channels: 8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol
Motor	Model: EX1002 20000KV Configu-ration:9N12P Stator Diameter:10mm Stator Length:2mm Shaft Diameter:1.5mm Motor Dimension(Dia.Len):13.5mm12.5mm Weight(g):2.5g No.of Cells(Lipo):1S only
Propeller Gemfan 1610-2 Bi-blades	Weight:0.24g Material: PC Pitch:1 inchProps Dia:40mm Center Hole Dia:1.5mm
Avatar mini VTX	Model: Avatar mini 1s module Communication Frequency: 5.725-5.850 GHz Transmitter Power(EIRP): FCC:<25.5dBm; CE:<14dBm; SRRC: <20dBm;MIC:<25dBm l/o Interface: JST1.O6(Power in)JST1.O4(USB) Mounting Holes: 25.525.5 mm Dimensions: 3333*6.5 mm Storage: 8G Recording: 1080p/720p Weight: 6.8 g Operating Temperature: -20-40 Channels: 8 Wide Power lnput: 3.1V-5V Supported FC System: Betaflight OSD: Canvas mode Bitrate: 25mbps / 50mbps Latency: Average delay 22ms Antenna connector: IPEX
Avatar nano FPV Camera	Model: Avatar nano lmage Sensor: 1/2.7"Inch Resolution: 1080P/6Ofps,720P/120fps,72OP/6Ofps Ratio: 16/9 4/3 Lens: 2.1mm FOV 170 Aperture: F2.0 Shutter: Rolling shutter Min.Illumination: 0.001Lux Weight: 3.5g Dimensions: 141417mm Coaxial Cable: 45mm

Resources

Moblite7 Walksnail Manuals, CLI Dump and Firmware files

Included

1 x Happymodel Moblite7 HD Walksnail Avatar
1x spare canopy (depending on supply so you may not receive this)
1x screw driver and prop removal tool (depending on supply so you may not receive this)

(0 ) Reviews:

No reviews yet. Be the first to review!