Description:
ExpressLRS is currently the most popular remote control link system. It has the characteristics of low latency and high packet rate, and its link quality is very reliable. Now we are happy to sell one of the most popular tiny whoops (Mobula6) in ELRS form. The new Mobula6 ELRS also includes new 0702 brushless motor, one of the lightest brushless motors in the world. Make the Mobula6 your go to whoop drone this Tiny Whoop Season.
Key Features
- AIO Flight controller with ELRS Receiver and 5.8G VTX
- Super light 1S 65mm Brushless whoop only 18.7g
- Equipment with the lightest brushless motors-SE0702 only 1.46gram
- Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera
- Smooth and powerful
- Compatible for 1S Lipo/LIHV
Specification
- Brand: Happymodel
- Item Name: Mobula6 ELRS 1S 65mm Brushless whoop drone BNF version
- Wheelbase: 65mm
- Size: 80mm*80mm*37mm
- Weight: 18.7g
- Voltage:1S
| Version |
2.4GHz ELRS
|
915MHz ELRS
|
868MHz ELRS
|
Color
|
Green
|
Blue
|
Blue |
| Flight controller |
ELRS F4 2G4 |
CrazyF4 ELRS |
CrazyF4 ELRS |
| Firmware target |
CRAZYBEEF4SX1280 |
CRAZYBEEF4DX |
CRAZYBEEF4DX |
| Built-in ExpressLRS receiver |
SPI 2.4GHz |
Serial-base 915MHz |
Serial-base 868MHz |
| Built-in Dshot ESC |
5A |
5A |
5A |
| Receiver antenna plug |
SMD ceramic antenna |
IPEX MHF3 |
IPEX MHF3 |
| Onboard VTX power |
25mw~200mw |
25mw~200mw |
25mw~200mw |
| Brushless Motor |
SE 0802 KV19000 |
SE 0802 KV19000 |
SE 0802 KV19000 |
| Propeller |
HQPROP 31mm Bi-blade |
HQPROP 31mm Bi-blade |
HQPROP 31mm Bi-blade |
| Battery |
1s 300mah Lipo battery |
1s 300mah Lipo battery |
1s 300mah Lipo battery |
Detailed Component Specifications
| Motor |
Mode: SE 0802 KV19000
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:1mm
Motor Dimension(Dia.*Len):9.5mm*14mm
Weight(g):1.46g
No.of Cells(Lipo):1S only |
| Propellers |
HQprop31mmx2
Center Thickness:5mm
Prop Disk Diameter:31mm
Center Hole Inner diameter:1.0mm
Weight:0.2g |
| Flight controller |
ELRS F4 2G4 flight controller built-in SPI expresslrs 2.4G receiver
CrazyF4 ELRS flight controller built-in 915MHz expresslrs receiver
CrazyF4 ELRS flight controller built-in 868MHz expresslrs receiver
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in ExpressLRS 2.4G/915MHz/868MHz receiver
Built-in 5V 1A BEC
Built-in voltage detection |
| Onboard 4in1 ESC |
MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_5_REV16_7.HEX
Default protocol: DSHOT600 |
| Onboard SPI ExpressLRS 2.4GHz Receiver (Optional) |
Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
RF Frequency: 2.4GHzAntenna : SMD antenna
Telemetry output Power: <12dBmReceiver protocol: SPI ExpressLRS
Could bind with Happymodel ES24TX , ES24TX Lite, ES24TX Slim and DIY 2.4GHz ELRS TX module ExpressLRS version 1.0.0 or 1.0.1 both compatible |
| Onboard Serial-based ELRS Receiver ( Optional) |
Operation current: ~100Ma
Rx To FC protocol: CSRF
RF Frequency optional: 915mhz or 868mhz(EU)
Antenna connector: IPEX4
Telemetry output Power: <17dBmFirmware target: Happymodel_RX_ES915RXReceiver protocol: CRSF
Could bind with Happymodel ES915TX , Frsky R9M and DIY ELRS TX module(need to flash the same version ELRS firmware)
Firmware flash via Betaflight pass-through |
| Onboard 5.8g VTX |
Output power: 25mw~200mw
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels
With Race bandSmartaudio ready |
| Runcam Nano3 |
Model: RunCam Nano 3
Image Sensor: 1/3 CMOS
Horizontal Resolution: 800TVL
Lens : 2.1mm(M8) FOV 160
Signal System: PAL/NTSC Non Switchable
S/N Ratio: >50dB
Electronic Shutter Speed: Auto
Auto Gain Control (AGC): Auto
Min. Illumination: [email protected]
D-WDR: Auto
Day/Night: Color
Power:DC 3-5.5V
Current: 110mA@5V [email protected]
Housing Material: ABS
Net Weight: 1.2g
Dimensions: L14mm*W14mm*H9mm |
| Lipo Battery |
Capacity:300mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Size: 57mmx12mmx7mm
Weight: 8gConnector: PH2.0 |
Included
- 1x Mobula6 1S FPV Racing Drone
- 4x 1S 300mAh 30C Lipo Battery
- 1x 1S Lipo/LIHV USB Charger
- 1x Propeller disassemble Tool
(0 ) Reviews:
No reviews yet. Be the first to review!